Small Capacity Hot Melt Opp Labeling Machine , Automatic Bottle
Labeler 5000BPH
Machine function:
Position on the round bottle and square bottle to paste OPP, BOPP
and paper labels which are rolling without glue. This machine will
deliver labels automatically, select and cut labels, glue at both
ends of each label, add labels and smooth out labels.
The machine suits for the application of mineral water, beverage,
food, washing and other industries to realize labels-cutting,
glues-coating and labelling for round bottles and square bottle.
Electric cabinet
1. General power supply switch
2. Touch screen
3. Emergency stop switch
The main control circuit of the electric cabinet integration system
is the location for layout and installation of electric components.
The electric cabinet is provided with two locks. After unlock them,
pull up the lock handle and turn it right to open the cabinet door.
The specific operation about the integrated man-machine interface
of electric cabinet can be seen in 3.1.
1.3.9. General power supply switch
The general power supply switch is located below the electric
cabinet at front of the machine (Figure 9). Turn the switch in the
clockwise direction to the position of ON to connect the power, and
turn the switch in the anticlockwise direction to the position of
OFF to disconnect the power.
1.3.10. Material-lack sensor
Inspect whether lacking material during the first transporting
period, if lacking material, send a signal to the control system
for stop. The machine is provided with the material-lack sensor in
order for no single bottle goes into the separating screw stem to
result the bottle down.
1.3.11. Emergency stop switch
The machine is provided with two emergency stop switches. One is
located above the touch screen and the other is located aside the
transport line (Figure 9).
When an emergency happens, please ensure to press the switch and
stop the whole machine. At that moment, the system information
section indicates that the emergency stop switch is not on and the frequency inverter
alerts! Just turn the top cap of the emergency stop switch in the
clockwise direction to set the emergency switch on.
1.3.12. Touch screen
With Chinese human-computer operation interface, the touch screen
is applicable to start/stop the machine, set/adjust various
parameters, and indicate/report production information!
1.3.13. System air pressure inspection
The machine is provided with an air pressure inspection device
(Figure 9). When the system air pressure is lower than the system
assumed value and insufficient to ensure the system run normal, the
machine may stop voluntarily, and the touch screen information
section indicates an alert report of <air pressure
insufficient>!
| Model | SSW-0806R(PO201607007) |
| Maximum label output speed | 60m/min |
| Maximum speed | 30,000 (determined by bottle size and label length) |
| Specifications for labeling bottle | Round bottle and square bottle |
| Labeling precision | ±1mm |
| Total power | 8Kw |
| Power supply | Three phase 380V 50/60Hz |
| Air pressure | 5 Kg f/cm2 |
| Air consumption | 20L/min |
| Outside measurement (LxWxH) | About 3000mm(L)×2000mm(W)×2000 mm(H) |
| Total weight | About 2500Kg |
